Check all aspects of the silicone dispenser before dispensing. If it is found that the environment of the dispenser is the same as before, such as checking the humidity display card in the package after opening, and the humidity on the humidity card of the dispenser is more than 20%, it indicates that the silicone dispenser has been affected with moisture. Today we are discussing how to deal with the moistened silicone dispenser?

The most simple, fast and effective way is to use the electric blast drying oven to bake the wet silicone dispenser. The baking temperature is controlled at 125 ℃ and the baking time is 10-20 hours. It also depends on whether there are bubbles in the glue of the dispenser. If there are bubbles in the glue, the compressibility of the gas is great. In the process of gluing, the gas is compressed, and the gluing is completed and the pressure is released. It shows that the glue drops until the pressure is balanced, or there is no glue in the hose, and the dripping stops.

Secondly, to check the rubber valve of the dispenser, the rubber valve seal wear is serious, also can appear the phenomenon that the glue is not clean. Then, the glue dispensing valve and mixing pipe are not tightly connected, which is also one of the reasons for this phenomenon. Therefore, when the glue is basically stopped, use a container to connect the glue to the machine until the glue does not leak. This is a relatively simple and easy-to-use way at present.